Woodworking engraving machine carved in the use of knife block

1, processing a metal box, metal block height must be accurate, smooth. On the metal punching, connected to a wire.

 

2, in woodworking engraving machine control electric box found 15 holes of the data line, welding line in the first pin, along the trough to above the Z axis, and the connection on the knife block

 

3, check whether woodworking engraving machine ground connection, ground and overall connection of the whole machine to machine, it can realize loop.

 

4, test, will have on the knife block contact with woodworking engraving cutter, look at the dimensions in the macro software I/O state of knife is there red dot into a green dot, and if so, will be successful!

 

5, click menu operation under the floating of cutter, woodworking carving machine Z axis will slowly down, run into the knife block is automatically bounce, implementation of automatic knife.

 

6, the thickness of the metal on the knife block need to engraving machine manufacturers parameters in the control software reset. Application Settings after click ok