Woodworking engraving machine mismatch

Computer woodworking carving machining stamp was half in carving carving carving machine suddenly the stamp course, but the NCStudio machining track display tips and no mistake, suspended after return to mechanical origin to press continue and will come back to continue to sculpture on the right place, but it didn't take long and will go wrong!

 

1, if there is a disturbance signal, that is, between the computer and woodworking engraving machine control cabinet wiring. We also met this kind of situation before, should be the signal interference, such as electrical wiring short circuit or poor contact.

2, check whether the woodworking engraving machine mechanical misalignment! Pay attention to the woodworking engraving machine in the process of using normal maintenance! Adjust the speed!

3, if confirmed the dislocation woodworking engraving machine, look around is wrong or before and after wrong, or wrong, if have wrong, speed may be set up quickly, and the software system of fault.