Computer engraving machine engraving knife solution

As is known to all, CNC computer engraving machine applicable range is very wide, can be applied to various fields and industries, suitable for all kinds of engraving and cutting. But some customers in cutting some yakeli board, foam and other low melting point of material, as a result of the engraving machine spindle high-speed cutting material, production of large amounts of heat caused by cutting material melt, stick to the cutting tool, carving processing, there is a kind of situation is carved in copper, aluminum and other materials, to produce pieces of cut, on the tools will be a lot of adsorption affects the cutting tool of carving processing. So, in computer engraving mechanic is should how to avoid this kind of material stick knife problems?

Treat carving is easy to melt material processing, the first thing to pay attention to the selection of sharp knives, cutting heat, thus reducing the second lower spindle speed, also like sex reduces the cutting speed, also avoid the generation of cutting heat, the third increase feed speed, shorten the time duration of the cutting tool in the same position, cutting materials received per unit area is reduced, also can avoid the melting of the carved material.

In cutting copper aluminum metal, the first to improve cooling method, before it is made of material on the note on butter, can avoid the generation of cutting heat, also can avoid cutting nitrate stick on the cutting tool, the second change of sharp knives, maximum reduce the cutting heat, third lower CNC engraving machine spindle speed, the fourth reduce feed speed.

Normally, using CNC engraving machine, carving processing is a sticky phenomenon when the name is mainly caused by the above two cases, according to the properties of the materials, using different processing methods, basically can be a very good solution to solve the phenomenon of knife carving viscosity happen!