Basic maintenance and advertising engraving machine parameter Settings

1, 10 hours a day under the continuous running time, guarantee the normal work of the cooling water clean and the water pump, must not water shortage phenomenon in a spindle motor, regular change of cooling

Water, in order to prevent the water temperature is too high. If working environment temperature is too low in winter can replace the water inside cistern with antifreeze.

2, each machine after use, should pay attention to clean up, be sure to clean up the dust on the platform and the transmission system, on a regular basis (weekly) for transmission system (X, Y and Z axis)

Come on. (note: X, Y, Z three axis polished rod with oil for maintenance; screw part with high-speed butter; winter if working environment temperature is too low screw, polished rod (square guide

Rail or circular guide) part should use gasoline to wash clean first, then add oil, otherwise it will cause machine transmission part of the resistance is too large and cause dislocation.

3, to electrical maintenance checks, must cut off power supply, to monitor display and main circuit power supply after lights out, may.

 

Engraving machine parameters of modified macro system (d) : vendor parameter modification, (input password: NCSTUDIO click "ok")

Table travel: (according to the machine model and decide)

System parameters: on the basis of the default and then the first four items are selected.

Motor parameters: if the lead is 10, 0.00625

If the lead is 5, 0.003125

Jump frequency: 300

The Z axis maximum speed: 1000

Single spindle acceleration: 400

Curve acceleration: 300